Serwis korzysta z plików cookies w celu świadczenia spersonalizowanych usług na najwyższym poziomie, w tym usług statystycznych oraz w celu dostosowania zawartości do indywidualnych preferencji użytkowników. Zapisywanie plików cookies można wyłączyć w ustawieniach przeglądarki. Więcej informacji
OK
Utwórz konto
[zamknij]     

LOCTITE FREKOTE Frewax - 1L (środek antyadhezyjny do form)

LOCTITE FREKOTE Frewax - 1L (środek antyadhezyjny do form) (IDH.381052)

Product description:
LOCTITE FREKOTE Frewax is a unique combination of a wax and a Frekote semi-permanent polymer release agent. This combination provides the user with the advantages of an easy-to-apply liquid wax and the multiple release performance of a polymer resin. By incorporating a wax into the formulation, a visible film is produced that enables easy, user-friendly application and complete mold coverage. Using LOCTITE® FREKOTE Frewax® provides significant process and labor savings through better mold utilization. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. Shake or stir LOCTITE® FREKOTE Frewax® before use.
2. Apply LOCTITE® FREKOTE Frewax® with a clean, lint free, cotton wiping cloth. Wet the cloth with LOCTITE® FREKOTE Frewax® until it is damp but not dripping.
3. Starting at one end of the mold, wipe a generous wet film over a 91 X 91cm area. Repeat until mold is completely covered.
4. Allow LOCTITE® FREKOTE Frewax® to haze (dry). This usually takes 5 to 10 minutes at 21°C with good ventilation.
5. Check mold for any region that appears uncoated (where haze is not present). If any uncoated areas are observed,reapply product in the above manner.
6. With a clean, lint free, cotton wiping cloth, polish the LOCTITE® FREKOTE Frewax® coated mold until a high gloss is obtained. Change cloth frequently to ensure wax build-up on the cloth is not re-deposited on the mold.
7. Repeat steps another 3 times to give a total of 4 coats. This multiple coat system allows the Frekote® resin to seal any mold pores and give a sufficient film thickness to permit multiple releases.
8. After the final film has been polished, the mold is ready for use

Storage:
The product is classified as flammable and must be stored in an appropriate manner in compliance with relevant regulations. Do not store near oxidizing agents or combustible materials. Store product in the unopened container in a dry location. Storage information may also be indicated on the product container labelling. Optimal Storage: 8 °C to 21 °C. Storage below 8 °C or greater than 28 °C can adversely affect product properties. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel cannot assume responsibility for product which has beencontaminated or stored under conditions other than those previously indicated.

Parameters:
  • Technology: Mold Release
  • Appearance: White or light creme suspension
  • Chemical Type: Solvent Based Polymer
  • Odor: Hydrocarbon
  • Cure: Room temperature cure
  • Cured Thermal Stability : ≤280 °C
  • Application: Release Coatings
  • Application Temperature: 15 to 35 °C
  • Specific Benefit:
    - High gloss finish
    - Multiple releases
    - Minimal mold build-up
    - Easy application
    -Low odor
    -Visible mold coverage

    Full technical information can be found in the technical data sheet
  • Asortyment