Serwis korzysta z plików cookies w celu świadczenia spersonalizowanych usług na najwyższym poziomie, w tym usług statystycznych oraz w celu dostosowania zawartości do indywidualnych preferencji użytkowników. Zapisywanie plików cookies można wyłączyć w ustawieniach przeglądarki. Więcej informacji
OK
Utwórz konto
[zamknij]     

LOCTITE 5102 - 300ml (anaerobowa pasta do uszczelniania, średnio demontowalna, nieprzejrzysta różowa)

brak obrazka

Product description:
LOCTITE® 5102™ cures when confined in the absence of air between close fitting metal surfaces. It is supplied in cartridges and is particularly suitable for robotic dispensing. Further information about the product: biuro@woronko-kleje.pl

Directions for use:
1. For best performance bond surfaces should be clean and free from grease.
2. The product is designed for close fitting flanged parts with gaps up to 0.25 mm (0.01 in).
3. Apply manually as a continuous bead or by screen printing to one surface of the flanges.
4. Low pressures (<0.05 MPa, 7 psi) may be used when testing to confirm a complete seal immediately after assembly and before curing.
5. Flanges should be tightened as soon as possible after assembly to avoid shimming.

Storage:
Store product in the unopened container in a dry location. Storage information may be indicated on the product container labeling. Product shall be ideally stored in a cool, dry location in unopened containers at a temperature between 8°C and 28°C unless otherwise labeled. Optimal storage is at the lower half of this temperature range. Material removed from containers may be contaminated during use. Do not return product to the original container. Henkel Corporation cannot assume responsibility for product which has been contaminated or stored under conditions other than those previously indicated.

Parameters:
  • Shear Strength (Cured for 1 h at 22 °C) Pin & Collar Shear, ISO 10123, N/mm²:
    - grit blasted : ≥1
  • Shear Strength (Cured for 24 h at 22 °C) Pin & Collar Shear, ISO 10123, N/mm²:
    - grit blasted : ≥7.5
  • Lap Shear, ISO 4587, N/mm² (psi):
    - grit blasted : 5
  • Tensile Strength, ISO 6922, N/mm²:
    - grit blasted 7.5

    Full technical information can be found in the technical data sheet.
  • Asortyment